This page and hopefully additional pages will be added as I receive more pic's from other builders. The pictures below are from a builder by the name of Chester who sent me his pic's for a listing of a partially fabricated ship frame he was looking to sell.

Here's a picture of Chester's partially completed bird. First thing I noticed was the large Plexiglas wind shield.	The picture above really shows the nice lines Chester followed with his pipe bending work. Look at the side tube coming down along the seat. The prints call for this to be a straight line providing for some maneuvers to get in and out. But Chester made the compound bend follow the chair line.
The 2 things I notice from this picture are the rear up right mounts and cross angle mounts were fabricated from channel and boltd through the rear weldment number 36A. While the keel tube was bolted to the front weldment number 47A using a split tube.	Tubes 48 and 49 shown clamped in to the 4 number 29 plates.
Rear side view of the collective bar and the number 29 plates and up right tubes number 48 & 49.	This side view again shows Chesters great tube bending and clean lines.

This site is maintained only as a way for those persons building a home built helicopter to find additional contact information and resources for building their personal project. For this reason this site, its mentioned information or contacts can assume no responsibility for any injury or death sustained during the building or flying of any such helicopter or aircraft. Any person building such a helicopter or aircraft assumes all liability personally.